Multitech MULTI MODEM II MT5600BA Uživatelský manuál stáhnout pdf (Strana 43)

4 AT Commands, S-Registers, and Result Codes

MultiModemII User Guide

Command: &E

Modem-Initiated Flow Control

Values: n = 3, 4, or 5

Default: 4

Description: &E3 Flow control disabled.

&E4 CTS/RTS hardware flow control.

&E5 XON/XOFF software flow control.

Note: See also the L5 and &K commands.

Command: &E

V.42bis Data Compression

Values: n = 14 or 15

Default: 15

Description: &E14 V.42bis data compression disabled.

&E15 V.42bis data compression enabled.

Note: This command controls only V.42bis data compression,

whereas the %C command controls both V.42bis and MNP-5

data compression. The command in effect is the one last en-

tered. See also the L5 command.

Command: &F

Load Factory Settings

Values: n = 0 or 1

Default: None

Description: &F0 Load factory configuration 0.

&F1 Load factory configuration 1.

Note: See also the Z, L5, and &V commands.

Command: &G

V.22bis Guard Tone Control

Values: n = 0, 1, or 2

Default: Varies by country

Description: &G0 Disables guard tone.

&G1 Sets guard tone to 550 Hz.

&G2 Sets guard tone to 1800 Hz.

Note: The &G command is not used in North America, and

may not be permitted in some countries.

Command: &J

Telephone Jack Control

Values: n = 0 or 1

Default: None

Description: &J0 NA

&J1 NA

Note: This command is included only for compatibility. It per-

forms no function except to load the S-register. The parameter

value, if valid, is written to S21 bit 1.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 112 113

Komentáře k této Příručce

Žádné komentáře

Multitech MULTI MODEM II MT5600BA Uživatelský manuál Strana 43

Komentáře k této Příručce

Související produkty a manuály pro Hardware Multitech MULTI MODEM II MT5600BA