Multitech MTA128ST-USB Uživatelská příručka stáhnout pdf (Strana 41)

Chapter 3 - AT Commands, S-Registers and Result Codes

Command: %C

Data Compression Control

Values:

= 0 or 1

Default: 1

Description: %C0 Disable V.42bis/MNP 5 data compression.

%C1 Enable V.42bis/MNP 5 data compression.

Command: %E

Fallback and Fall Forward Control

Values:

= 0, 1, or 2

Default: 2

Description: %E0 Disable fallback and fall forward.

%E1 Enable fallback, disable fall forward.

%E2 Enable fallback and fall forward.

Command: #S

Enter Setup Password

Values:

= password (1–8 characters, case sensitive)

Default: MTSMODEM

Description: Enters the remote configuration setup password.

Command: #S=

Store Setup Password

Values:

= password (1–8 characters, case sensitive)

Default: MTSMODEM

Description: Stores a new remote configuration setup password.

Command:+++AT<CR> Escape Sequence

Values: n/a

Description: Puts the modem in command mode (and optionally issues a command) while remaining online.

Type +++AT and up to ten command characters, then press ENTER. Used mostly to issue the

hang-up command: +++ATH<CR>.

Command: %%%AT<CR>Remote Configuration Escape Sequence

Values: n/a

Description: Initiates remote configuration mode while online with remote modem. The remote configuration

escape character (%) is defined in register

S13

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 83 84

Žádné komentáře

Multitech MTA128ST-USB Uživatelská příručka Strana 41