Multitech MMH900 Uživatelská příručka stáhnout pdf (Strana 126)

126

Appendix D - Command Modem Commands

&F Load Command Modem Factory Defaults

The Load Command Modem Factory Default &F

Command resets the S-Registers and command

modem commands to thefactory default values.

They are as follows:

S-Registers: S0=0, S1=0, S2=43, S3=13, S4=10,

S5=8, S6=2, S7=30, S8=2, S9=6, S10=14,S11=95,

S12=50, S18=0, S25=5, S26=1, and S28=0.

Commands:

Command Name Default

B1 Answer Tone: Bell

E1 Echo: Enabled

P Dialing: Pulse

Q0 Result Codes: Enabled

V1 Result Codes: Word

X4 Result Code Set/

Call Progress: Dial Tone

& Busy

H0-1 Hanging Up, and Bringing thePhone Line Off

Hook

You can make the command modem hang up (go

On Hook), or go Off Hook, with the H command.

Entering ATH1 (upper case) will bring the line Off

Hook just as if you had picked up the telephone

handset. The command modem remains in

command mode.

You can hang up by entering ATH0 or ATH

(remember that the default value is 0 when nothing

is entered). It is not necessary to use the H1

command to bring the line Off Hook when using the

command modem D command to dial, since the

modem will go off hook automatically when you hit

Return at the end of the Dial command.

I Inquiry for Product Code

Some systems or software packages may

automatically check the “identification” of the modem

with which they are communicating, by using the I

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 199 200

Žádné komentáře

Multitech MMH900 Uživatelská příručka Strana 126