Multitech MTASR2-201 Uživatelská příručka stáhnout pdf (Strana 9)

V.35 Shunt Procedure

4 Place the unit on a flat, grounded surface.

5 Pry the shunt out of the RS232 position, and insert it in the

V.35 position. See Figure 5.

V.35 Shunt Position

RS232C Shunt Position

Back Panel Connectors

8-Position DIP Switch

RAM Sockets

LEDs

Figure 5. Shunt Positions

Note: if you wish to make changes to the 8-position DIP

switch, do so at this time. For details on DIP switch

settings, refer to the previous section, “8-Position DIP

Switch”.

6 Align the board with the guide slots on the inside of the

chassis and carefully slide the board back into the chassis.

7 While supporting the back panel, turn the DSU

RouteFinder over again, and replace the cabinet mounting

screw.

8 Turn the DSU RouteFinder right side up again and

proceed to the next section to connect the cables.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Žádné komentáře

Multitech MTASR2-201 Uživatelská příručka Strana 9