Multitech MTT1DSU Uživatelská příručka stáhnout pdf (Strana 19)

Cabling Your MultiDSU

Cabling your MultiDSU involves making the proper Power, Command

port, Line, and Data port connections. Figure 2-2 shows a typical

application for the MultiDSU. Figure 2-3 shows the back panel connec-

tors and associated cable connections, and Table 2-1 contains the

procedures for connecting the cables to your MultiDSU.

LINE

COMMAND

POWER

Device

Connection

Power

Connection

To Telco

Slave MultiDSU

(back to back)

Figure 2-3. Cable Connections

Table 2-1. Cabling the MultiDSU

1. Connect a V.35 interface cable to the Winchester type Data

connector on the back of the MultiDSU. Connect the other end of

the cable to your DTE device (e.g., a router or frame relay access

device). Refer to Appendix A for cable details.

2. Connect the special serial cable's RJ45 connector to the COM-

MAND jack on the back of the MultiDSU, then make sure the other

end of this cable is connected to a serial (COM) port on your

terminal or PC.

3. Connect the T1 line (or back-to-back cable) to the mating RJ48

LINE connector on the back of the MultiDSU.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

Žádné komentáře

Multitech MTT1DSU Uživatelská příručka Strana 19