Multitech BL-Series Uživatelský manuál stáhnout pdf (Strana 29)

AT Commands for the MT5656ZDX, MT5600ZDX, MT5600BA/BL-Series Modems

Multi-Tech Systems, Inc. Commands Reference Guide (PN S000273D)

Command: -QCPS Enable Quick Connect Profile Save

Description: This command controls whether or not the modem will save the generated quick connect

profile.

Syntax: -QCPS=<value>

Defined Values: <value> Decimal number corresponding to the desired operation.

0 Do not allow the quick connect profile to be saved.

1 Allow the quick connect profile to be saved. (Default.)

Result Codes: OK 0 or 1 in V.92 Mode (+MS=V.92) and quick connect is enabled (+PSS = 0)

ERROR Otherwise

Reporting Selected Value(s):

Command: -QCPS?

Response: -QCPS: <value>

Example: -QCPS: 1 For the default setting.

Reporting Supported Range of Parameter Values:

Command: -QCPS=?

Response: -QCPS: (<value> range)

Example: -QCPS: (0,1)

Command: –STE= Set Telephony Extension

Description: The –STE command enables/disables Line-In-Use, Extension Pickup, and Remote Hangup

detection features.

Note: Additional hardware may be required to support these features.

Syntax: -STE=<value>

Defined Values: <value> Decimal number corresponding to the selected bit-mapped options. The bit fields

are defined as follows:

Bit 0 Line-In-Use detection enable/disable.

Bit 1 Extension Pickup detection enable/disable.

Bit 2 Remote Hangup detection enable/disable.

<value> Remote Extension Line-in-Use

(Dec.) Hangup Pickup

0 (default) Disabled Disabled Disabled

1 Disabled Disabled Enabled

2 Disabled Enabled Disabled

3 Disabled Enabled Enabled

4 Enabled Disabled Disabled

5 Enabled Disabled Enabled

6 Enabled Enabled Disabled

7 Enabled Enabled Enabled

Reporting Current or Selected Values:

Command: -STE?

Response: -STE: <value>

Example: -STE: 4 Remote Hangup enabled, Extension Pickup disabled; Line-In-Use

disabled.

Reporting Supported Range of Parameter Values:

Command: -STE=? Show available options.

Response: -STE: 0-7

Result Codes: OK <value> = 0-7

ERROR Otherwise.

Behavior in Data Mode (+FCLASS=0):

When on-hook, if the line is in use and an ATDT is issued, the modem will not go off-

hook and will return with the message LINE-IN-USE.

When off-hook and either an extension is picked up or a line reversal is detected, the

modem will drop the connection. The disconnect reason in register S86=25 (also

defined for #UD). The user must flash the hook in order to get a dial tone because the

remote server will be retraining.

If local handset is picked up while modem is off-hook, modem will do a link-disconnect,

flash the hook for 1.5 seconds, then connect local handset to the line. Now, the user

dial tone is on the local handset. Disconnect reason S86=25.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 59 60

Komentáře k této Příručce

Žádné komentáře

Multitech BL-Series Uživatelský manuál Strana 29

Komentáře k této Příručce

Související produkty a manuály pro Sítě Multitech BL-Series