Multitech CDMA Specifikace stáhnout pdf (Strana 61)

Chapter 11 – Provisioning Control Commands

Multi-Tech Systems, Inc. CDMA C1 AT Commands Reference Guide 61

Request PRL Version Information +WPRL

Description: This command requests PRL Version information for the currently selected NAM.

Notes: The range for PRL is a 16-bit type.

The module service programming code must be successfully entered before

using this command. See +WSPC.

Syntax: AT+WPRL?

Command

Possible Responses

AT+WPRL?

Note: Request current NAM’s PRL version

+WPRL: 1024

AT+WPRL?

Note: Request current NAM’s PRL version

+CME ERROR: 41

Note: PRL request invalid because there’s no

PRL loaded.

AT+WSPC=1,000000

Note: Enter service programming code. The

SPC code for your modem may be different

Commit Changes +WCMT

Description: This command is used to commit or to undo/revert any changes done during the service

programming session. Changes performed during this session will not take place until a commit

command has been sent (AT+WCMT=1). Commission of these changes will force a software

reset of the modem. Sending this command indicates this service provisioning session is

complete. To perform any subsequent provisioning, use the +WSPC command to enter the

service programming code.

Syntax: +WCMT=<val>

Command

Possible Responses

AT+WCMT=0

Note: Undo any changes performed during this

provisioning AT session

AT+WCMT=1

Note: Commit all changes performed during this

provisioning AT session to non-volatile memory.

Note: software reset is

performed

Values: <val>

0 undo changes

1 commit changes

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 128 129

Žádné komentáře

Multitech CDMA Specifikace Strana 61