Multitech CF220 Uživatelská příručka stáhnout pdf (Strana 23)

Chapter 3: CallFinder Server Installation

Multi-Tech Systems, Inc. CF220-DID CallFinder User Guide 23

2. Connect CallFinder to Power

Insert the 9 V dc power connector into the CallFinder’s power receptacle and fasten it with the lock nut.

Connect the female end of the AC cord to the power block. Then plug the AC cord into the power outlet.

Caution: Use only the 9 V dc power transformer supplied with the CallFinder. Use of any other

transformer voids the warranty and can damage the CallFinder.

Figure 3-2: Connect to power

3. Verify powering.

After power is applied, the PWR LED comes on immediately but there is a 4-second delay before the

Status LED comes on. In normal operation, the Status LED will be flashing.

When you apply power, the CallFinder performs a diagnostic self-test. The Status indicator flashes when

the embedded processor is up and running. If the Status indicator does not flash, check that the power

supply is solidly connected and that the AC outlet is live.

Figure 3-3: Front panel LEDs

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 75 76

Žádné komentáře

Multitech CF220 Uživatelská příručka Strana 23