Multitech MT5634HD16 Technické informace stáhnout pdf (Strana 24)

Frequently Asked Questions (FAQs)

Q52. How can I get my CommPlete system to be able to make

central site originated calls (with callback security) at V.90

rates?

A52. Central site call origination is available with a firmware upgrade (see Q14).

Additional Questions

Q53. How do I set up Dial-Up Networking (DUN) in Windows

95/98/NT to dial into the CommPlete Server?

A53. Each operating system uses different interfaces when configuring DUN. In

addition, different versions of DUN have different settings available to change. In

any case, however, the required settings are essentially the same.

The most common application for DUN is “remote node,” or dialing into a

network. To configure DUN for this purpose, set the following options:

1. Server Type = “PPP: Win 95/Win NT Internet”

2. Network Protocol = “TCP/IP”

3. TCP/IP settings = default: IP address and Name Server addresses should be

server-assigned; Use IP Header Compression should be unchecked to

reduce the time it takes to log into the server; Use Default Gateway on

Network should be checked.

These settings match up with the default settings in the RASExpress software on

the CommPlete RASCard.

Q54. How do I set up RASExpress to accommodate certain users

who need static IP addresses while the majority of my users

use dynamic IP addresses?

A54. This feature requires setting up an address pool in RASExpress and configuring

RADIUS to assign static or dynamic IP addresses. Follow these steps during a

low-traffic period to configure RASExpress:

1. Connect to the RASCard via Telnet. Choose Configuration of server, and

2. Choose Configure IP Address Pool. If an address pool is not configured,

then enter the first IP address and last IP address in the address pool, if

there are no addresses present. You must have an address pool if you

configured your RADIUS server to allow RASExpress to assign addresses.

(If configured to do so, RADIUS can assign dynamic addresses.)

3. Press Esc then change Remote Client IP Address to Use Radius.

4. Press Esc. RASExpress will ask you if you want to save the changes. Type

5. Press Esc until you are disconnected from the RASCard. As you press

Esc, RASExpress will ask you if you wish to reboot the server. Type y

because the server needs to reboot for the changes to take effect. This will

cause anyone connected to the server to be dropped, which is why this

should be done during a low-traffic period.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Žádné komentáře

Multitech MT5634HD16 Technické informace Strana 24